Changing the Color or Material of a Single Wall
| Reference Number: KB-00005 Last Updated: 05-12-2015 03:06 PM
The information in this article applies to:
I want to change the color of a single wall in my room to create an accent wall, but when I use the Material Painter tool in a 3D view, it changes the color or material of all the walls in my room. How can I change the color of just a single wall?
The Material Painter will paint the entire room when you try to paint a wall. In the Wall Specification dialog, you can adjust the material of a single wall by going to the Materials panel or by using the Wall Covering panel.
To change the material of an entire wall
- First, use the Select Objects tool to select the wall that you want to adjust and click on the Open Object edit tool to display the Wall Specification dialog.
You can select the Wall in either a 2D floor plan view, or in a 3D camera view, to open its specification dialog.
If you are in a 3D camera view, selecting the wall will select the room first. This can be verified by looking at the left of the Status Bar at the bottom of the screen. If the room highlights first, click on the Next edit button, or press the Tab key on your keyboard, to select just the wall itself.
- Go to the Materials panel, and select either the Exterior Wall Surface or the Interior Wall Surface that you want to change..
Note: Recall that in Chief Architect, when you draw walls in the recommended clockwise fashion, the exterior surface will display as outward. Even Interior walls have an "Interior" and an "Exterior" surface, based on the direction that the wall was drawn.
- Click on the Select Material button to display the Select Material dialog.
Once you have selected the material that you want to use, click OK to close the Select Material dialog.
- On the Library Materials panel, click the arrows in the catalog list to browse the various categories available, and expand them to locate the material you want to apply to the wall.
- On the Plan Materials panel you will find a list of materials that have been used in this plan, allowing you to easily locate previously selected materials.
Note: X6 and prior versions have separate Library Material and Plan Material buttons on the Wall Specification dialog.
Click OK again in the Wall Specification dialog to apply the change in material or color to the wall.
In some cases, such as when an exterior wall runs the length of several rooms, you may not want to change the material of the spanning wall, or you may want to apply different colors to several different sections of the same wall to create a striped effect. You can use Wall Breaks to accomplish bot of these tasks.
If you are in a 3D camera view, return to your 2D floor plan view for the following steps.
To change the material of a section of wall vertically
To apply a different color or material to a section of a given wall, Wall Breaks will need to be placed on either side of the section that we want to change.
- To use the Break Wall tool, select Build> Wall> Break Wall and click on the wall where you want to place the wall break.
Note: The Break Wall tool remains active, so that you can continue to place as many breaks as needed. When you are finished, choose a different tool, or press the spacebar hotkey on your keyboard in order to return to the Select Objects mode.
- After you have used the Break Wall tool to place break points on the wall for separate wall sections, use the instructions above to change the material on just that section of the wall.
Note: The Break Wall tool applies a break in a wall. Once a wall is broken, the two wall segments are separate walls that can be modified independent of each other.
If a wall break is placed near the intersection of two walls, the break is positioned at the center of the intersection.
Walls separated by a break can be rejoined. Select one of the segments, then click on the end edit handle located at the break and drag it a few plan inches (mm) away from the break
Another solution would be to draw a Wall Material Region in the area that you want to display differently, though this adds more than just a color to the pre-existing wall surface, and is better suited for facade walls. See the Related Article below for information on Material Regions.