Browse
Categories

Exploding a Resized CAD Block

Reference Number: KB-00014 Last Updated: 10-11-2013 02:17 PM

The information in this article applies to:

Chief Architect Premier or Chief Architect Interiors or Chief Architect Lite


QUESTION

I'm not able to explode a ­CAD block. When I click the Explode CAD Block edit button,  I get a warning message that reads:

"Cannot explode block when x and y scaling is different."


ANSWER

CAD blocks are a collection of lines, polylines and other CAD objects that have been grouped together to form a single object that can be easily placed, selected and moved without affecting the appearance of the drawing.  To edit the objects that make up a CAD block, it must first be unblocked, however, if the CAD block has been stretched so that it no longer has the same aspect ratio, it cannot be unblocked.


To explode a resized CAD block

  1. Using the Select Objects   tool click on the CAD block to select it, then click the Open Object    edit button.


  2. On the General panel of the CAD Block Specification dialog:  

     

  • Specify both the Height Factor and Width Factor as 1 in the Size section.

  • Click OK to close the dialog and apply your change.

  • With the CAD block still selected, click the Explode CAD Block   edit button to break the CAD block into its individual components, which can then be edited.