Browse
Categories

Creating a Manual Attic Wall

Reference Number: KB-00083 Last Updated: 10-10-2013 02:42 PM

The information in this article applies to:

Chief Architect Premier or Chief Architect Interiors or Chief Architect Lite


QUESTION

I have a gap between my deck ­beam and the gable roof above it.  There is no ceiling in the Deck  room, so no gable roof generates above this area. How can I fill in the gap with a manual attic wall?


ANSWER

It's easy to manually create attic walls to fill in gaps, such as in gables where the program can't determine where one is needed, or if you have turned off the automatic generation of Attic Walls.

 

To manually add a gable wall

  1. Launch Chief Architect and Open the plan in which you need to manually draw in the gable wall.



    In the example above, we want to fill in the gap between the beam above the deck railing and the underside of the gable roof planes, while still not having a ceiling over this area.


  2. In your 2D floor plan view, locate the wall or railing that you want to draw in the attic wall above.




  3. Next, select Tools> Reference Floors> Up One Floor .


  4. Go to Tools> Reference Floors> Reference Display , so that you can see a red outline of the Deck Railing below.


  5. From the menu, go to Build> Wall> Straight Exterior Wall , then click and drag in the wall the same length as the Deck Railing below it.



    If your upper floor is on the Attic level (Floor A), and you receive a warning message about drawing objects on the Attic level, click OK.


  6. Once placed, use the Select Objects tool to select the Wall, and click on the Open Object edit button to display the Wall Specification dialog.


  7. On the General panel, place a checkmark next to Attic Wall, then click OK.




  8. Finally, generate a 3D Full Camera view to see the results of your filled in gable end.