I have a multiple floor structure, and I would like to know how to align the walls of the structure from one floor to another and then check to make sure the alignment is satisfactory.
Checking wall alignment between floors is easily done using the Reference Display and the Align With Wall Above and Align With Wall Below edit tools.
To turn on the Reference Display
Select Tools> Reference Floors> Change Floor/Reference from the menu.
In the Change Floor/Reference dialog:
Click the desired Current Floor on the left side to select it. This floor will be the active floor in floor plan view and can be edited.
In the right margin, click to select the desired Reference Floor. Objects on this floor will display as uneditable red lines on the Current Floor.
When you are satisfied with your selections, click the OK button to close the dialog.
Select Tools> Reference Floors> Reference Display from the menu to display the Reference Floor selected in step 3, above.
You can control which objects are included in the Reference Display by selecting Tools> Display Settings> Display Options from the menu.
To learn more, see the article on Displaying the Reference Floor linked at the bottom of this article.
To align regular walls on different floors
Click the Select Objects button, then click on a wall to select it.
Use the Move edit handle that displays at the location on the wall where you clicked to move the wall into position over a wall shown in the Reference Display.
Do not worry about exact placement at this time. Just make sure that the lines representing the two walls overlap in floor plan view.
Click on the Align With Wall Above or Align With Wall Below edit button.
By default, walls on different floors are aligned by the outer edges of
their Main Layers and in most circumstances, the Main Layer should be
specified as the structural layer of the wall, particularly when the
wall is a framed type.
To align curved walls between floors
Curved walls are aligned between floors using the same technique to align straight walls.
If the centers and radii of the walls are within a few inches of each other, the Align With Wall Above and Align With Wall Below edit buttons are enabled for the selected wall.
The selected curved wall will take on the radius and center of the referenced wall when the walls are aligned.
To align Pony Walls between floors
When aligning a pony wall with either the wall above or below:
Align With Wall Above will always align the upper pony wall with the wall above, as specified in the upper pony wall's Wall Type Definition.
Align With Wall Below will always align the lower pony wall with the wall below, as specified in the lower pony wall's Wall Type Definition.
To align Foundation walls between floors
The Foundation To Selected Line setting in the Wall Type Definitions dialog controls how a wall of a given type aligns with foundation walls directly below on Floor 0.
By default, Foundation To Selected Line is specified for the Main
Layer of most wall types. An exception to this are brick wall types,
which have Foundation To This Line specified for the exterior brick layer.