Browse
Categories

Creating Mitered or Wrap Around Stairs

Reference Number: KB-00788 Last Updated: 11-10-2014 02:59 PM

The information in this article applies to:

Chief Architect Premier or Chief Architect Interiors or Chief Architect Lite


QUESTION

How do I create mitered or wrap-around stairs on a deck?

 


ANSWER

In Chief Architect X1 and later, you can easily create wrap-around or mitered stairs on a deck or other structure by simply dragging the stair edges to the corner where they should join.


To miter stairs

  1. Select Build> Railing and Deck> Straight Deck Railing  and draw a rectangular deck on your structure.




  2. Select Build> Stairs> Click Stairs .



    • Click once just on the outside edge of the deck railing that is parallel with structure to place a set of stairs.

    • Click again just to the outside edge of the deck railings that is perpendicular to the structure to place another set of stairs. 

       
  3. Click the Select Objects  button, then click on one of the stair sections to select it.  
     
    • Place the cursor over the edge move handle closest to the corner of the deck.

    • Left-click and drag the edge of the stairs towards the corner to increase the width of the stairs.  
       
       

    • Repeating the same steps on the other stair section. 

    • Once both stairs sections are within 6 inches of the corner, the program will automatically wrap the stairs around the corner.

       

    • This process works for any angle you may have on your deck, to allow for a wide array of unique designs to fit any need.


    • This process also works for outside or inside corners of decks.

       
    • This process also works on interior railings.


  4. Select 3D> Create Perspective Camera> Full Camera  to see the results.