Browse
Categories

Removing a Molding from a Single Wall

Reference Number: KB-01959 Last Updated: 04-15-2014 07:30 AM

The information in this article applies to:

Chief Architect Premier or Chief Architect Interiors


QUESTION

Is there a way that I can control which wall receives a ­molding?


ANSWER

You can control the molding on a wall-by-wall basis in Chief Architect by using a Room Molding Polyline.


Creating the room molding polyline

  1. Select a room in your plan and click the Make Room Molding Polyline  edit button.


  2. Select from a list of moldings currently applied to the room (or choose Blank Molding) and give it a height.



  3. Click OK to apply the room molding. 


  4. Now, select the molding polyline on the edge you wish to remove the molding from and click Open Object .


  5. On the General panel, check the box titled No Molding on Selected Edge.



    • If you chose Blank Molding in step 2, or if you need to select a new or additional molding profile you can do this on the Moldings panel.


  6. Click OK.

The molding will now display on all edges of the room except the edge you selected.