Browse
Categories

Changing the Pitch of a Single Automatic Roof Plane

Reference Number: KB-00045 Last Updated: 10-03-2013 02:41 PM

The information in this article applies to:

Chief Architect Premier or Chief Architect Interiors or Chief Architect Lite


QUESTION

Most of my roof has an 8:12 ­pitch, but the ­shed roof over the porch has a pitch that is only 3:12.  What do I need to do to automatically build a roof with more than one pitch, such as in the image below?  





ANSWER

In Chief Architect, you can quickly build an automatic roof based on the settings in the Build Roof dialog.  If you need different settings for a particular roof plane in your plan, you can specify these special settings on the Roof panel of the Wall Specification dialog of the wall that this roof plane will bear on when built.  


To specify a single automatic roof plane's pitch

  1. Using the Select Objects  tool, Click on the wall that the roof section you wish to change will bear on to select it, then click the Open Object edit button.   


  2. On the Roof panel of the Wall Specification dialog, specify the desired Pitch.


  3. You can also specify how far this roof pitch builds into the structure before it meets the steeper pitch.  To do this, check the box beside Upper to enable the settings that follow, and then:



    • Specify the desired Upper pitch. In this example, this is 8" in 12".

    • Specify where to Start the upper pitch - by either specifying at what roof Height to transition from lower to upper pitch, or the measurement in from Baseline where the transition should occur.

    • In this example, the porch room is 72" deep, so this value is specified In from Baseline.


  4. Repeat steps 2 and 3 for all walls that will support a roof plane with a non-default pitch. 


  5. Select Build> Roof> Build Roof from the menu. In the Build Roof dialog, specify the desired default pitch for your roof, then click OK

    • The roof that results will have the default pitch over all non-gable walls except those for which you specified a different pitch.